1:10 Onroad Nitro Touring 200mm
- All .12 (2.11cc) Engines are allowed.
- Engine internal modifications are allowed.
- All Mufflers are allowed.
- Minimum weight without fuel: 1,725.00 grams (including transponder).
- Fuel tank capacity to be 75.00cc including all fuel tubing, filters, etc. No loose inserts allowed inside the tank.
- All Sedan Touring 4 doors bodies are allowed.
- The body must be made from a flexible material and be painted properly. All windows must remain clear and not be painted over or be semi-transparent.
- The front bumper must follow the body contour and must be constructed so as to minimise injury that may result from being hit by a car. The bumper must be made from foam rubber or a flexible plastic material.
- Bodies are not to be cut above the lower bumper line at the front or the back or above the bottom line of the doors.
- No parts of the car, except the muffler outlet may protrude outside of the body shell when viewed from above.
- Track width minimum 170mm and maximum 200mm.
- Wing width inclusive minimum 125mm and maximum 200mm.
- All Tires are allowed with maximum width 30mm.
- All Fuels are allowed.
- Only two (2) servos are allowed. Frequency must be legal as specified by Race Director.
- The use of electronic gyroscopes is not allowed.
1:8 On-Road Nitro
- All .21 (3.5cc) Engines are allowed.
- Engine internal modifications are allowed.
- All Mufflers are allowed.
- Minimum weight without fuel: 2,525.00 grams (including transponder).
- Fuel tank capacity to be 125.00cc including all fuel tubing, filters, etc. No loose inserts allowed inside the tank.
- All Lola/Canam bodies are allowed.
- Track width maximum 267mm.
- Wing maximum width 267 mm, maximum length 77 mm, maximum height 191 mm
- All Tires are allowed with front tires maximum width 37mm and rear tires maximum width 64mm.
- All Fuels are allowed.
- Only two (2) servos are allowed. Frequency must be legal as specified by Race Director.
- The use of electronic gyroscopes is not allowed



General Informations